Inhoudsopgave
Advertenties
49 / 112 | EN
and then counter-clockwise.
Slipping when turning
The surface of the thumb turn cap can be slippery and the
cap can be difficult to turn (especially with WP versions, re-
cognizable by the blue cylinder neck ring or the lasered
marking on the inner side of the cylinder profile).
Wear non-slip gloves.
5. Remove the tool and cover.
6. Insert the hexagonal wrench into the hole provided until
it stops.
7. Turn the hex wrench 270 degrees counterclockwise.
8. Pull out the hexagon wrench again.
9. Pull off the thumb turn.
Electronic thumb turn is disassembled.
9
Installing the escape thumb-turn
1.5 mm hexagonal wrench available.
ü
5. Installation on the removed cylinder (anti-
NOTE
clockwise unlocking)
Advertenties
Inhoudsopgave
