Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
• All moving parts must be re-lubricated periodically!
Lubrication (fig. 4, 5)
This tool does not need to be greased every hour or
every day as it has a grease-lubricated lubricant sys-
tem. For a longer service life of the tool, however, the
lubricant should be changed after 40-50 hours.
1.
Operate the tool for a few minutes to warm it up.
2.
Turn off the tool and pull out the mains plug.
3.
Open the lid (3) with the supplied maintenance tool
(C).
4.
Wipe the old grease off the inside and replace
it with new grease (20-30 g) (not included in the
scope of delivery). (fig. 5)
5.
Afterwards, close the lid again.
Carbon brushes
• If excessive sparks are generated, have an
electrician check the carbon brushes. Attention!
The carbon brushes must only be replaced by an
electrician.
Service information
With this product, it is necessary to note that the
following parts are subject to natural or usage-related
wear, or that the following parts are required as
consumables.
Wearing parts*:Carbon brushes, chisel
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
Ordering spare parts
Please provide the following information when ordering
replacement parts (via the service-hotline):
• Device type
• Device article number (see packaging or instruction
manual)
12. Cleaning
12.1 Cleaning
Keep protective devices, air vents and the motor housing
as free of dust and dirt as possible. We recommend
cleaning the device directly after every use.
12.1.1 Exterior cleaning
• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.
13. Storage
Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store the power tool in its original packaging.
Cover the electric tool to protect it from dust or
moisture.
Store the operating manual with the power tool.
14. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed non-destructively before disposal. Their
disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 23
Advertenties
Hoofdstukken
Inhoudsopgave
