Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is between 10-
32°C. If the ambient temperature is above or below recommended temperatures, the performance of the unit may be
affected and it may not be possible to obtain temperature between 5-18°C.
1)
Light button
2)
Compartment selection button
3)
Temperature displays
4)
Button to increase temperature
5)
Button to decrease temperature
To switch the wine cellar on or off, press buttons 1 and 2 simultaneously. To change the temperature reading unit,
press the light button (1) for 5 seconds. The display will show the selected temperature unit (°C or °F).
It is possible to adjust the temperature degree by degree; the temperature can be adjusted with the keys 4 or 5 to the
right of the temperature display. In first, the desired compartment must be selected by pressing button 2. The
temperature range of this cellar is between 5°C and 18°C in each zone.
To turn on or off the indoor light, press button 1. The light (LED) is suitable for storing wine. However, it is advisable
to turn off the light in normal use.
IMPORTANT: the temperature selected for the upper compartment must always be lower than the
temperature selected for lower compartment (2-compartment model).
Temperature display
The appliance designed to display setting temperature.To check cabinet's actual temperature, press key 4 during 5
seconds, The value will turn back to setting temperature with another 5 seconds.
Note : The actual temperature is given for information only, it cannot be adjusted and depends on the different
cooling phases. A deviation of +/- 2°C from the selected temperature is normal.
The temperature display will flash if:
-
The temperature in the zone deviates by more than 5°C from the set temperature. The temperature display flashing
ensures that the temperature cannot rise or fall un-noticed and impair the wine.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner temperature will not
immediately be the temperature shows on the display. Indeed, it is necessary to wait a few hours for a temperature
adjustment of the wine cellar in order to have a homogeneous temperature. To avoid excessive condensation when
the ambient temperature is above 28°C, do not lower the temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to wait 5 minutes
before turning it on again. Otherwise, the wine cellar will not turn on.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take around 30
minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same circumstance, it will take
around one hour to decrease the wine cooler's temperature from 12℃ to 5℃. The less the temperature span
is, the less time it will take. The setting temperature of upper zone should be lower than the setting
temperature of lower zone
1
2
3
4
5
Advertenties
Inhoudsopgave
