2.
SPEED: Fan speed can be switched between high or low.
Note: In comfortable mode ("AU") when the room temperature is more than 27
degree, the wind speed is fixed.
3.
UP-DOWN (HUM+ HUM-) Set the required humidity among the follows: "CO"
(continuous), "30%", "50", "35%", "40%", "45%", "50%"...... "85", "90", "AU"
(comfort), "CO" (continuous) cycle. The default mode is "CO".
Note: Press UP and DOWN at the same time to convert display of temperature or
humidity, the indicator "Cº" being for temperature and "%" for humidity.
4.
TIMER: Timing setting.
A. In the power-on state, press the TIMER key to set the timer for the scheduled
shutdown. In the off state, press the TIMER key to set the timer and when to start
the dehumidifier.
B. Regular time range: 01~24 hours, timing setting: 000102......232400 cycle.
C. When the timing is set to power on, the timing setting is completed and the timing
is displayed. When the timing is set to off, the timing setting is completed and the
humidity is displayed after 5 seconds.
5.
MODE key: mode conversion: dry clothes, fan, dehumidification.
6.
Pump automatic pumping function On/Off button: PUMP indicator, continuous
drainage opening and closing.
7.
Swing: On/Off control of the "Swing" function.
After machine turns on, press this key, the louver will swing continuously up and
down; by pressing this button again the movement will stop and the louver remain in
that position.
8.
Child lock: Long key This key is 5 seconds for child lock switch selection.
After child lock is turned on, all button operations except child lock buttons cannot
be operated.
9.
Hidden display: Dual 8-screen display on synchronous main operation display panel.
Note: After the operation is completed 10S, all lights (including double 8) are all
dimmed.
OPERATION
1.
Humidity automatic control operation function:
A. When "CO" (continuous) operation is set to dehumidify, the dehumidifier will
continue to operate regardless of the humidity level.
B. If the indoor humidity is higher than or equal to 3% or more of the set humidity,
the compressor and fan will run. The indicator light of the compressor will be on.
C. After the humidity in the room is dehumidified, when the humidity drops below
2% of the set humidity, the compressor is turned off and the dehumidification is
stopped. The indicator lamp (OK lamp) that reaches the humidity is on.
D. If the dehumidifier stops dehumidifying and the humidity in the room rises above
or equal to 3% or more of the set humidity, if the compressor has passed the
three-minute protection status, the compressor will start dehumidifying.
E. According to the above cycle operation, the indoor humidity can be maintained
at the set humidity.
2.
Comfort (shows "AU") function:
A. Below 5°C at room temperature, the dehumidifier stops.
B. 5 °C ≤ room temperature ≤ 20 °C, automatic selection set 60% humidity.
C. 20°C<room temperature ≤27°C, automatically select setting 55% humidity.
D. Room temperature> 27 °C, automatic selection set 50% humidity.
4
68