Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
BOOST FUNCTION
The Boost function allows you to activate timed operation at maximum power without the thermostat control. At the end of this
forced operation, the heater returns to the operating mode prior to activation.
To activate the function press and at the same time the buttons
splay. The duration can be chosen between the values of 60, 90 or 120 minutes (2h) using the buttons
after the last selection the function is activated.
If the remaining time is less than or equal to 59min the display shows the remaining minutes of heating. If higher the display
shows the remaining minutes preceded by the word "1h" shown for 3 seconds.
7.
Troubleshooting
•
In the event of overheating, the safety device on the appliance automatically disabled the heating element. In this case:
-
Turn off the radiator and allow it to cool down for about 15/20 minutes.
-
Eliminate any other possible reasons for overheating (e.g.: obstructions in front of the air inlet/outlet grilles, build-
ups of dirt).
-
Turn on the radiator and check it works correctly.
•
If the touch control commands are blocked or don't properly answer to digital pressure, turn off the heater for 1min and
then try again.
8.
Maintenance
•
This product does not require any special maintenance.
•
Clean the product with a dry cloth once every 6 months.
•
If the product requires repairing, contact an authorised technical service centre.
•
When replacing the power cable, use a 2x1,00mm
lified personnel and never by the end user in order to avoid damaging the appliance and jeopardising personal safety.
9.
Legal notice
Environment and recycling
Please help us to protect the environment by disposing of the packaging in accordance with the national
regulations for waste processing.
Recycling of obsolete appliances
Appliances with this label must not be disposed off with the general waste. They must be
collected separately and disposed off according to local regulations.
M
and
. The default duration of 60min flashes on the di-
H05V2V2-F HAR type. This operation must be performed by qua-
2
29
and
. 5 seconds
Advertenties
Inhoudsopgave
