Advertenties
Beschikbare talen
Beschikbare talen
4.4
Cooling mode (only for Pico R)
Step 1 : Press
Step 2 : Press
Step 3 : Using buttons
EXAMPLE :
If the current temperature is 30°C, default setting temperature is 27° required temperature is 15°C.
4.5
Status values and advanced settings
The system's settings can be checked and adjusted via the remote control by following these
steps
Step 1 : Keep pressing
Step 2 : Press
Step 3 : Press
Parameters table
Paramètres
Ambient temperature
d0
Water inlet temperature
d1
d2
Exhaust temperature
outside coil temperature
d3
Compressor
d4
Fan motor
d5
Four way valve
d6
Reserved - Do not adjust
d7
Reserved - Do not adjust
d8
Water flow switch
d9
14 |
EN
4. Use
to switch on your pump.
to switch from one mode to another until the cooling mode is displayed.
and
select the required temperature.
until you enter the settings verification mode.
and
for see the parameters.
to select the setting to be viewed.
Description
Range value
Comment
-20~80°C
Measured value
-20~80°C
Measured value
-20~140°C
Measured value
-20~80°C
Measured value
ON/OF
ON/OF
ON/OF
ON/OF
Advertenties
