Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Turn off WiFi: Long press the
20 seconds to turn off.
Emptying the Dustbin
1.With the power off, push down the dust empty
tab to clean the dustbin. If too much dust
causes a blockage, press the release button on
the dustbin and empty the contents.
Fig.D-6
2.Close and click the dustbin flap back into
place.
Fig.D-7
Charging the Battery
1.Plug the adaptor into the charging port at the
bottom of the dock.
Fig.D-8
2.Place the appliance on the charging dock and
plug the adaptor into a wall outlet.
Fig.D-9
Warning:
• Only use the Tineco-provided adaptor to
charge the appliance.
• To avoid trip hazards, please place the
appliance securely on the charging dock, near
a wall during charging.
• During long periods of not being used, store
the appliance in a cool, dry place. Ensure the
battery is fully charged every 3 months.
• Do not expose appliance to sunlight or
freezing temperature.
• Recommended temperature range: 39.2°F
(4°C)~104°F (40°C).
Runtime
• When in AUTO mode, the runtime is
approximately 40 minutes. When MAX power is
used, the runtime is approximately 10 minutes.
• Estimated runtime data was obtained by a
Tineco Laboratory using one battery and non-
motorized accessories.
Charging Time
button for
AUTO
MAX
• A full charge takes approximately 3-4 hours.
• Estimated data was obtained by a Tineco
Indicator
For any of the following notifications, consult the
"Troubleshooting" section of this manual.
When in Use
23
Laboratory using ambient temperatures
between 39.2°F (4°C) to 104°F (40°C).
Battery level > 20%:
solid green light.
Battery level ≤ 20%:
solid red light.
Blinking red light: fault.
Blinking: brush roller has a
blockage.
Blinking: appliance has a
blockage, either in the filter or
the dustbin.
Blinking: sensor inside the
dustbin is obstructed, or
the dustbin is not correctly
installed.
Blinking: motor failure.
Illuminated: WiFi has
successfully connected.
Blinking: WiFi is connecting.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
