Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The UA-767
cuff to a systolic pressure level automatically.
If your systolic pressure is expected to exceed 230 mmHg, refer to
"Measurement with the Desired Systolic Pressure" on the next page.
Normal Measurement
1.
Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2.
Press the
START
All of the display segments are displayed.
Then the display changes, as indicated in
the figure at the right, as the measurement
begins. The cuff starts to inflate. It is
normal for the cuff to feel very tight. A
pressure bar indicator is displayed, as in
the figure at the right, during inflation.
Note: If you wish to stop inflation at any time,
press the
3.
When inflation is complete, deflation starts
automatically and the
blinks, indicating that the measurement is
in progress. Once the pulse is detected,
the mark blinks with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
4.
When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
5.
Press the
device off.
Note: Allow at least three minutes between measurements on the same
person.
Measurements
BT-Ci is designed to detect the pulse and to inflate the
button.
button again.
START
(heart mark)
button to turn the
START
English 14
At heart level
button
START
All of the display
segments
displayed
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
Pulse rate
Exhausts remaining
air automatically
Advertenties
Hoofdstukken
Inhoudsopgave
