Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10. Appliance installation
10.1 Wall mounting
Material losses
!
Only mount the natural stone heater on a flat wall, as
otherwise cracks may develop in the natural stone
panel due to stresses. In the event of unevenness in
the mounting wall, level the surface before tighten-
ing the fixing screws.
Material losses
!
Do not tilt or tip the natural stone heater. Otherwise,
it may break.
Material losses
!
If the fixing screws are over-tightened, the rawl plugs
in the natural stone panel may over-rotate and be-
come loose.
» Measure dimensions a and b for the drill holes on the
natural stone heater.
» Based on the measurements, drill the holes in a wall
with sufficient load-bearing capacity. Maintain a safe-
ty margin of 100 mm on all sides (e.g. dimension b +
100 mm).
» Screw the hexagon screws far enough into the
drill holes that the natural stone heater can still be
hooked over the screw heads with the open slots in
the wall mounting brackets.
» Hang the natural stone heater. Tighten the hexagon
screws. Relieve any stress by slightly loosening the
fixing screws in the natural stone panel. Then retight-
en the fixing screws.
10.2 Power supply
Material losses
!
Only shorten the power cable far enough to be able
to hang the natural stone heater without disconnect-
ing the power cable.
Only connect the natural stone heater to an alternating
voltage of 230 V / 50 Hz.
L
N
PE
N
N
L'
L
NSH
Installation - for contractors
11. Initial start-up
Material losses
!
When heating up the natural stone heater for the first
time, observe a maximum heat-up time of 20 min-
utes. Then let the panel cool down for at least 60 min-
utes.
» Perform this process one more time.
In the first two days of use, heat up the natural stone
heater step-by-step to the required room temperature.
This way, you avoid hairline cracks. If hairline cracks do
develop, these are harmless and do not impair the func-
tion or the safety of the natural stone heater.
12. Handover
» Explain the functions of the appliance to the user.
Draw special attention to the safety instructions.
» Hand over the operating and installation instructions
to the user.
13. Specification
13.1 Dimensions and connections
B
a
13.2 Minimum clearances
70
40
230 V
23 23
15
Advertenties
Hoofdstukken
Inhoudsopgave
