BX 2E-15E
User and installation instructions
GB
Use
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction con-
cering use of the appliance in a safe way and understand
the hazards involved, Childen shall not play with the
appliance. Cleaning and user maintenance shall not be
made by children without supervision.
Children aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that it has
been placed or installed in its intended normal operating
position and they have been given supervision or instruc-
tion concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3
years and less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
CAUTION – Some parts of this product can become
very hot and cause burns. Particular attention has to be
given where children and vulnerable people are present.
The electric fan heater is intended for space heating in
various premises. The electric fan heater is approved for
use in humid and wet areas, and is employed on building
sites, in stores and shops, and in the home. The fan heater
has been subjected to electrical safety testing and EMC-
testing by SEMKO. The fan heater is CE marked. Degree
of protection: IP X4 (corresponds to splash-proof)
Safety
• Don't use this heater in the immediate vicinity of a
shower, bath or swimming pool.
• Don't cover the heater since it could then overheat and
could cause a fire (see also Figure A).
• Some of the heater surfaces become hot when the
heater is in operation.
• Locate the heater so that any combustible material will
not be ignited.
• Don't locate the heater immediately below a permanent
wall-mounted power outlet.
Operation
Thermostatically controlled fan motor
The fan motor will stop when the thermostat has
switched off the heater.
1. Fan (BX 9AE Low speed)
2. Fan + 1/2 output (BX 5ER - 2/3 output)
3. Fan + 1/1 output
Continuous operation
The fan motor runs continuously regardless of the
thermostat setting.
4. Fan (BX 9AE High speed)
5. Fan + 1/2 output (BX 5ER - 2/3 output)
6. Fan + 1/1 output
Thermostat, 0 – 35°C
7. The thermostats in BX 2E and BX 3E have one
output stage, while other models have two output
stages.
1
2
3
Cleaning
The fan heater is equipped with childproof safety grid
at the fan motor as required by the test standard. This
means that there is a greater risk of clogging.
heater at regular intervals, since dust and dirt may cause
overheating and give rise to the risk of fire.
Service and repairs
The following work should be done by personnel from
the manufacturer or a service company, or by equivalent
qualified personnel:
Changing the power supply cable.
The heater has a built-in temperature limiter that will
trip the power supply in the event of overheating. If the
temperature limiter has tripped, isolate the power supply
to the heater, allow the heater to cool down and attend
to the fault.
Installation
The heater must not be used for fixed installation, since
it does not meet the ecodesign requirements for room
heaters acc. Commission Regulation (EU) 2015/1188.
6
A
4
7
5
6
Clean the