A wide variety of external equipment can be connected via the sockets located behind the door on the right
side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
touch controls on the front of the television may be used for some functions.
Switching on
If the red LED is unlit check that the mains plug is
connected to the power supply. If the picture does not
appear press a number button on the remote control, it
may take a few seconds.
To put the television into Standby press
control. To view the television press
the number buttons. The picture may take a few seconds
to appear.
To set up the television you will now need to use the
on-screen menus. Press the MENU button on the
remote control to see the menus.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing the S or R button on the remote
control, its respective options will appear below.
To use the options press the Q button on the remote
control to move down through them and OK, S or R to
select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
Connections and controls
EXIT
i
on the remote
i
again or any of
MENU
Standby
RED LED– Power On
GREEN LED
Using the controls and connections
To alter the volume press —
To alter the programme position press
Press MENU and S , R , Q or P to control the sound
and picture options.
Press EXIT to finish.
When connecting mono sound equipment to EXT5,
connect the audio output of the equipment to the
L/Mono socket on the television.
To select the Input, press
EXT5 as described on page 19. The television will
automatically sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
8
INPUT 5
(EXT 5)
+
j
.
e e
f f
F
.
B
until the display shows