Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Note – charging procedure
• A complete charging cycle takes about 2.5 hours
• The controller's rechargeable battery can be charged both when it is connected
and when on standby.
• If the battery capacity is too low, the player LED will ash and the vibration
function will start
• Please use the enclosed USB-C cable only for charging the controller.
• The actual battery life will vary depending on how you use the device, the settings
and the environmental conditions (batteries have a limited life).4.3 Additional keys
4.3. Additional keys
• The following action keys can be assigned to the additional keys:
1/2/3/4/L/R/L2/R2/L3/R3/ D-PAD
• Individual functions or key combinations can be programmed.
• Your settings remain active after an interruption to the connection.
• Programming mode is aborted after 30 seconds.
• Programming mode is ended after 25 keys.
4.4 Programming the additional keys
• Press and hold the respective M button and Start brie y.
• The four LEDs will now ash alternately.
• Now enter the individual key or key combination.
• To nish, press the relevant M key again.
• To delete the M keys, hold "Start" and an M key pressed.
• Now press the M key for which you wish to delete the setting.
5. Turbo function
• The following action keys can be assigned a Turbo function: 1/2/3/4/L/R/L2/R2/L3/R3
• To assign the relevant key, press and hold the action key and Turbo key at the same
time.
• To remove the Turbo function, repeat the procedure.
• Your settings will be reset after an interruption to the connection.
6. Auto function
• The following action keys can be assigned the Auto function:
1/2/3/4/L/R/L2/R2/L3/R3
• To assign the relevant key, press and hold the action key and then press the Turbo
key twice.
• To remove the Auto function, repeat the procedure.
• Your settings will be reset after an interruption to the connection.
4
Advertenties
Inhoudsopgave
