Inhoudsopgave
Advertenties
DO419BL
For attaching jug, first place the jug into the motor unit, then turn it in
clockwise (see fig.1).
Note: make sure the jug is assembled into the motor unit properly, there is
interlock switch on the position, if the jug is not assembled properly, the
blender will not operate.
BLENDING FRUIT AND VEGETABLE:
ATTENTION : don't mix boiling or very hot liquids.
1. Before attaching the power cord into the outlet, make sure the speed selector is in
the 0 position.
2.
Peeled or cored the fruit or vegetables and then cut it into small dices, put the
food piece into the jug. Usually certain amount of purified water has to be added to
facilitate the smooth running of appliance. The proportion of the food and water is 2:3.
The amount of mixture should not exceed the max level as indicated on the jug.
Note: never use boiling liquids or run the appliance empty.
3. Replace the top lid on the jug. Only directly place the top lid into the jug.
4. Turn the speed selector to the desired setting, there are four setting: P, 0, 1, 2. The 1
setting is the low speed, the 2 setting is the high speed. Turn switch to P position and
hold it to pulse actuate motor for delicate chopping. Release it to return the 0 position.
5. You may add ingredient into the jug through the center opening of top lid during
operation, then replace Measuring Cup if necessary. Let the tab of Measuring Cup
aligns with the groove of top lid, put down and turn clockwise until it is locked.
6. The consecutive operation time shall not exceed 3 minutes. Minimum 1 minutes
rest period is required between two consecutive cycles.
7. Turn the Speed selector to 0 Position once the mixture has been blended to your
desired consistency.
8. Remove the jug from the Motor Unit by lifting it up, carefully take down the top
lid, then pour and serve.
CLEANING AND MAINTENANCE
The Auto Clean feature can clean the blender and blade assembly easily, rapidly in
complete safety.
Pour a little warm soapy water into the jug and turn the Speed Selector to P position
for a few seconds.
Remove the jug from the motor unit by turning it in anti-clockwise and rinse the jug,
top lid under running water.Wiping the outer surface of Motor Unit with a damp cloth,
do not use abrasive cleansers. Never immerse in water for cleaning
Dry all parts and then replace them
For complete cleaning, you can remove the blades at the bottom of jar carefully. For
removing the blades use the transparant measuring cup of the lid, according
to the drawing. BE VERY CAREFUL.
Attention : the blades are not dishwasher safe.
16
Advertenties
Inhoudsopgave
