Rx Receiver Wiring (Rf Models Only) - Danfoss TP5001 Series Installatiehandleiding
Electronic programmable room
Verberg thumbnails
Zie ook voor TP5001 Series:
- Gebruikershandleiding (4 pagina's) ,
- Instructies voor gebruik (105 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2) limit sensor, for example, fl oor temperature sensor (sold as
accessory).
3) window contacts, card reader contacts or teleswitch contacts.
See Installer Advanced Programming Options for set-up instructions.
Models with remote sensor inputs
Terminal block for remote control/sensing
is located on the circuit board above the
battery compartment.
S1/D
S2/E
Confi gured for
remote room
sensor or limit
sensor
RX Receiver Wiring (RF models only)
RX1
ELECTRONICS
N L
1 2 3 4
COM
1) For mains voltage operated systems link terminal 2 to mains live supply.
2) Power supply to unit must not be switched by timeswitch.
S1/D
S2/E
Window or
teleswitch
contact
(NO or NC)
Confi gured for
window contact or
other contact such
as teleswitch
RX2 & RX3
A
ZONE
ZONE
1 ON
1 OFF
ELECTRONICS
B C 1 2 3 4 5 6
N
L
COM
ZONE
/D
/E
Remote
control
connections
S1/D
S2/E
Window
contact (NC)
Teleswitch
contact (NC)
Confi gured for
window contact
and other contact
such as teleswitch
TERMINAL 6
RX3 ONLY
ZONE
ZONE
ZONE
1 ON
1 OFF
2 ON
3 ON
GB
5
Advertenties
Inhoudsopgave
