Advertenties
Beschikbare talen
Beschikbare talen
English
Commissioning
Installing the heater (⌦A)
1. Remove the transportation protection
2. Connect the suction device
3. Connect the suction device mount to the heater (not in the area
4. Attach the appliance below water level on the inside of your
▶ The heater must be rinsed well in order to guarantee consistent
▶ Only install the heater in a vertical position.
Operation
System requirement
WLAN-enabled terminal device (smartphone, tablet, notebook etc.)
Creating the network
1. Insert the mains plug in the mains socket. The status LED
‧ The status LED 昀氀ashes white: The network is being searched
‧ The status LED illuminates blue: A new network has been
Connecting to the WLAN network
2. Open the network settings of your terminal device (smartphone,
3. Connect the terminal device to the WLAN network (SSID)
4. Enter the network security key.
The SSID and network security key are found on the mains cable's
label. Alternatively, you can also scan the QR code 1 (see label) to
establish the connection.
Calling up the website
5. Open your web browser and enter the following address:
Alternatively, you can also scan the QR code 2 (see label) to open
the software in the browser.
Initial con昀椀guration
6. Select the desired language from the language selection and
Meaning of the control light
‧ The control light illuminates red: Heater heats su昀케ciently
‧ The control light is o昀昀: Heater does not heat
Meaning of the status LED
‧ The status LED 昀氀ashes white: The network is being searched for or created
‧ The status LED illuminates blue: Heater is in master mode
‧ The status LED illuminates green: The heater is connected to another EHEIM
digital device
Reset
1. Press the reset button
‧ When the status LED lights up green, the reset is complete. The
‧ The network security key and QR code 1 are invalid. It is possi-
Before you remove the heater
WARNING! Burning and 昀椀re hazards due to hot surfaces.
▶ Allow the appliance to cool down in the water for at least 30
of the heating zone
⑦
LED
).
aquarium (⌦B/C). Take the minimum water level into account.
water heating. Therefore, place the heater in an area with a
strong 昀氀ow.
illuminates.
for or created
created (master mode)
tablet, notebook etc.).
EHEIM heater XXXXXXXX.
http://192.168.1.1
follow the instructions for the initial con昀椀guration.
⑥
⑦
⑦
status LED
lights up and changes colour.
automatic heater restores the network.
ble to connect up the network without the network security key
minutes before removing it.
③
to the suction device mount
④
, the control light
①
for approx. 8 – 10 seconds until the
13
⑤
.
⑥
and the status
②
.
⑦
Advertenties
