Advertenties
Beschikbare talen
Beschikbare talen
4-OPERATION
4-OPERATION
PRELIMINARY OPERATION ON FIRST START-UP
The first operation is to pair the remote control with the stove by following this procedure:
•
connect the stove to the power supply
•
go near (40-50 cm) the stove's emergency panel (see the image to the side)
•
click on any key on the remote control for 5 seconds
•
wait for a buzzer to indicate that pairing has completed successfully.
ATTENTION! In the case of a non-visible emergency panel, refer to the product's
user manual to identify its position rapidly.
ATTENTION! If the remote control is not paired with the stove, it is not possible to
access the SETTINGS menu.
HOW TO DISCONNECT THE REMOTE CONTROL
To disconnect the remote control from the stove, proceed as follows:
•
move approximately 3/5 metres away from the stove
•
first press key 8 (SILENT) followed by key 11 (ON/OFF) for 5 seconds
•
release key 11 first and then key 8
•
the remote control is disconnected
MENU SETTING (
)
With the remote control connected to the stove, we can proceed with the various menu settings by pressing key 1. When the function is
not used for a few seconds, it exits the screen. To access it once again, press key 1 again.
The menu options are as follows:
•
LANGUAGE
•
DATE
•
TIME
•
BOARD INPUTS
•
ECOSTOP HYSTERESIS
•
ECOSTOP DELAY
•
TIMER T1-T2-T3
•
DAYS TIMER
•
BEEP ON / OFF
•
SLEEP
•
FEED SCREW ON
•
AIR RECIPE
•
PELLET RECIPE
Technical Dept. - All rights reserved - Reproduction is prohibited
Technical Dept. - All rights reserved - Reproduction is prohibited
PAIRED REMOTE CONTROL PANEL
DISCONNECTED REMOTE CONTROL PANEL
EN
EN
53
53 53
Advertenties
Hoofdstukken
