Advertenties
Beschikbare talen
Beschikbare talen
Vita V
Load Label Roll in Tear-off Mode
NOTICE!
As for the electrostatic unloading the thin coating of the thermal printhead or other electronic parts can be
damaged, the label material should be antistatic.
The use of wrong materials can lead to printer malfunctions and the guarantee can expire.
H
G
F
•
Open the printer cover.
•
Open the printhead (G) by turning the pressure lever (F) anticlockwise.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
•
Lead the label material below the return pulley (C) and the printhead (G).
Pay attention that the label runs through the photocell (E).
•
In order to move the printhead (G) down, turn the pressure lever (F) in clockwise direction until it locks.
•
The tear off edge (H) is visible in front of the printhead.
•
Enter the offset value in the menu Print settings/Tear-off.
•
Adjust the adjusting ring (D) of the return pulley (C) to the width of material.
•
Close the printer cover.
96
E
D C
English
A
B
Advertenties
Hoofdstukken
