Advertenties
Beschikbare talen
Beschikbare talen
3. Insert the battery into the cutting tool.
4. Release the control switch.
▶
The green LED flashes twice; acoustic signal sounds twice: starting lock activated
▶
Green LED flashes once; acoustic signal sounds once: starting lock deactivated
2
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶
Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds securely.
▶
Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
Operation
Observe the safety instructions and warnings in this documentation and on the product.
3
Making the cut
DANGER
Electric shock hazard! Working in adverse outdoor conditions can cause electric shocks and/or short circuits.
▶
Never work on electrically live lines while a thunderstorm is in progress.
▶
Call a halt to work immediately whenever weather conditions impair the insulation characteristics, vision or movement of the workers.
WARNING
Risk of injury due to oil escaping under high pressure! Oil escaping under high pressure can injure the skin and the eyes.
▶
Do not use the cutting tool if damage is visible.
▶
Do not use the cutting tool if oil escapes.
▶
Make sure that the piston retracts after every cutting operation.
▶
If the piston does not retract after the cutting operation, press the piston return switch for manual retraction.
WARNING
Risk of injury due to flying fragments! Flying fragments present a risk of injury to the eyes and body.
▶
Wear eye protection and protective gloves.
▶
Use cutting blades that are suitable and sharp.
▶
Before the cutting operation, make sure that the cutting blades are correctly inserted and sharp.
WARNING
Risk of injury! Risk of serious injury during the cutting operation.
▶
During the cutting operation great care must be taken to ensure that the hands and fingers are kept well clear of the cutting head.
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶
Wear protective gloves when changing the accessory tool.
▶
Never lay down a hot accessory tool on a flammable surface.
In cold weather the hydraulic oil can thicken and slow the cutting operation. Perform 5 to 10 empty cutting operations to heat up the
cutting tool.
1. Turn the cutting head to the desired position.
2. Insert the cable to be cut into the cutting head.
Do not attempt to cut a cable that cannot be fully enclosed by the cutting head.
Do not exceed the maximum cutting capacity.
3. Press and hold down the control switch until the cutting blade in the cutting head retracts.
16
*2321715*
2321715
Advertenties
