1. Lowest handle height
setting
2. Middle handle height
setting
3.
Tighten the handle bolt until it is snug.
4.
Repeat the steps above for the other side of the
machine.
3
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine, but it does come with a bottle of oil.
Before starting the engine, fill the engine with oil.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1.
Move the machine to a level surface.
2.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out
All manuals and user guides at all-guides.com
Figure 5
3. Highest handle height
setting
With oil filter: 0.85 L (29 fl oz);
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
g021150
1. Full
2. High
3.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4.
Wait 3 minutes for the oil to settle in the engine.
5.
Wipe the dipstick clean with a clean cloth.
6.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7.
Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5
through
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine-Oil Level (page
Important:
low or too high and you run the engine, you
may damage the engine.
8.
Install the dipstick into the oil-fill tube securely.
Important:
Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to
Changing the Engine Oil (page
6).
6
Figure 6
3. Low
(Figure
7
until the oil on the dipstick is at
Checking the
10).
If the oil level in the engine is too
18).
g194742
6).