Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Adjusting the connection current:
The appliance is plugged in. The shirt ironer is
off and the programme selector switch 4, Fig.
1, is set to "0". The button band is fully lifted.
Press the
and the start/stop buttons in at
the same time and keep them pressed in.
Three sound signals are emitted to confirm
the operation.
Digital screen 5, Fig. 1, displays the current
the appliance is set to.
Press "Start/stop". The screen displays the
connection current setting. Press the same
button again to change the current.
Three sound signals are emitted to confirm
the operation.
Press
when the current you wish to
work at is displayed on the screen; the shirt
ironer switches itself off and the new setting
is stored in the memory.
The ironing time is longer with the 10-Amp
setting.
The 16-Amp setting is recommended for
enhanced performance.
Adjusting the signal
Sound signals are emitted to indicate that a
specific circumstance has taken place in the
programme.
Change in the connection current setting.
End of ironing and airing cycle.
All manuals and user guides at all-guides.com
Before using your shirt ironer
7
Adjusting the indicator light
The
light flashes 10 times when the
appliance is already at its lifted position
when plugged in.
The
light flashes 10 times when the
appliance is lifted from its down position
when already plugged in.
The light flashes to remind you to press
the
button at the start of use in order to
initiate preheating and thereby reduce shirt
drying time.
The
light lights up when the appliance
is working.
The start / stop light and the
up when the appliance is blowing air, in any
cycle.
When the appliance is on pause, the start /
stop light flashes for the 30 seconds that
this function lasts.
Adjusting the size
The size of the ironing dummy is based on
European shirt sizes. The size can be
adjusted between sizes 35 and 50. These
sizes coincide with American sizes XS and
4XL. In the case of blouses, sizes 36/38 to
50/52 (S to XXL) can be used.
The ironing dummy can be adapted to
different cuts (e.g. tapering, blouse cuts) by
adjusting the size. This is done by adjusting
the 3 adjustment cords 16, Fig. 2. To adjust
the size, start by adjusting the top cord. The
volume of the ironing dummy cannot be
reduced when inflated.
2 button arm straps are supplied for ironing
short-sleeved shirts, Fig. 3.
light light
Advertenties
Hoofdstukken
Inhoudsopgave
