Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Hot air in the "
cold"
programme.
The light is flashing
Low air pressure in
the ironing dummy
Excessive air pressure
in the ironing dummy.
No air pressure in the
arms
Ironing process too long. The 10 A version was used.
The ends of the
adjustment cords used to the gap on the button band.
regulate size have
become hooked up on
the appliance.
The fuse triggers when
the appliance is
connected.
You hear a noise on
raising or lowering the
appliance.
All manuals and user guides at all-guides.com
Before calling the Technical Service
Possible cause
This is not a fault! Residual heat.
The start/stop button has been pressed It stops after 30 seconds or
during an ironing cycle: pause function. when start/stop is pressed.
The light flashes 10 times on plugging
the appliance into the electricity supply appliance is ready for
with the button band already lifted.
The
light flashes 10 times
on raising the appliance to its upper
position when it is already plugged in.
The preheating time has finished.
The ironing dummy has not been
fitted properly.
The air filter is dirty.
Faulty ironing dummy.
The airbag is not fitted properly.
The ironing dummy arms are twisted.
The airbag arms are not inside the
ironing dummy arms.
The end of the cord has splipped into
The wrong connection current has
been selected.
This is because the internal tube is
sliding
Solution
The hot air disappears after a
short period of time.
This indicates that the
operation.
This indicates that the
appliance is ready for
operation.
This indicates that the
preheating time has finished
and you have 5 minutes to
press the Start/ Stop button
before the appliance switches
itself off.
Fit the ironing dummy
correctly.
Clean the air filter.
Replace the ironing dummy.
Check the airbag adjustment
cords and adjust them
correctly
Set the arms in the right
position.
Insert the airbag arms in the
ironing dummy arms. Fig. 25.
Switch over to the 16 A
version if possible.
Press the button band adjuster
in and pull on the cord.
Select the right connection
current. See "Changing the
connection current".
This is not a fault and does
not affect correct operation
of the appliance.
16
Advertenties
Hoofdstukken
Inhoudsopgave
