Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
c) Tariff settings
First select the desired currency (1, £, SFr or $, applies for both tariffs) with the two arrow keys. With the
„Continue" arrow key (7) you can set the first tariff. The arrow keys (3 and 4) change the value, the „Con-
tinue" arrow key (7) changes the decimal position. Repeat these steps until the second tariff is also set.
The comma cannot be changed.
Confirm your settings after the last figure of the 2nd tariff with the „MODE" key (5). The basic settings are
saved and you automatically reach the normal measuring operation.
Measuring operation
Due to the many display functions, the measuring values can only be displayed via several displays. Up
to three values can be displayed simultaneously.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key
(7) for the previous display. Every time you press, you switch the display.
After switching on the electric consumer, the energy cost measurement device needs a
couple of seconds to display the measurement values. During this time all required para-
meters are measured and calculated.
The energy cost measurement value records from the time of launching the data for current, power and
performance factor without interruption, but for a maximum of 6 months. The free memory in the internal
memory is illustrated by a percentage display next to „MEM".
a) „Power1" display for current, power and
frequency
After connecting the measurement device, this display is always shown.
In the bottom right corner the load type (capacity/resistance) can also
be seen as a symbol. If no device is connected, no symbol appears.
The maximum and minimum
values are saved by the measu-
ring device automatically. Via the
„max" (4) or „min" (3) keys, the
values are displayed for approx.
10 seconds. Pressing the key
again switches back to the normal
display prematurely.
29
Advertenties
Hoofdstukken
Inhoudsopgave
