24
What to do if...
Problem
The appliance does not op‐
erate.
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig‐
erator.
All manuals and user guides at all-guides.com
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains sock‐
et correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" .
This is correct.
Clean the water outlet.