Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Connection
a) DMX512 Connection / Connection between Fixtures
Only use a stereo shielded cable and 3-pin XLR plugs and connectors to connect the controller with the fixture or one
fixture with another.
Occupation of the XLR connection: If you are using controllers with this occupation, you can connect the DMX output
of the controller directly to the DMX input of the first fixture in the DMX chain. If you wish to connect DMX controllers
with other XLR outputs, you need to use adapter cables.
Building a serial DMX chain: Connect the DMX output of the first fixture in the chain with the DMX input of the next
fixture. Always connect one output with the input of the next fixture until all fixtures are connected.
At the last fixture, the DMX cable has to be terminated with a terminator. Solder a 120 resistor in a 3-pin XLR plug
between pins 2 and 3. Plug the connector into the DMX output of the last fixture.
b) Mains Connection
Connect the device to the mains using the power cable. The occupation of the connection cables is: brown (Live L),
blue (Neutral N), yellow/green (Earth). The earth has to be connected! If the device will be directly connected with the
local power supply network, a disconnection switch with a minimum opening of 3mm at every pole has to be included
in the permanent electrical installation.
6. Use
After connection, your VDP150MH6N starts running. During the reset, the motors are trimmed and the device is
ready fur use. Turn the focus screw next to the objective lens for adjusting the focus in order to obtain a sharp
projection.
a) Display and Function Buttons
Press the FUNCTION button and select from function 1 to 4.
Function
Pan Reverse
F1
Reverse the pan movement.
Tilt Reverse
F2
Reverse the tilt movement.
16-bit Operation
F3
Reduce the projector movement to 16 bit.
Demo Operation
F4
Use the device without controller in stand-alone mode.
b) DMX-controlled operation
You can control the projectors via your DMX controller. Every DMX channel has a different occupation with different
features.
VDP150MH6N
Description
• Press FUNCTION and select F1.
• Press UP to select Y or N if you want to
select this function or not.
• Press FUNCTION and select F2.
• Press UP to select Y or N if you want to
select this function or not.
• Press FUNCTION and select F3.
• Press UP to select Y or N if you want to
select this function or not.
• Press FUNCTION and select F4.
• Press UP to select Y or N if you want to
select this function or not.
5
Use
VELLEMAN
Advertenties
Inhoudsopgave
