Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
11. TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
All manuals and user guides at all-guides.com
Width / Height / Depth
(mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Possible solution
Close the water tap and contact the Service.
penser and use rinse aid together with
the combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate
the appliance.
2. Make sure that the appliance is in
setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B)
and (C) at the same time until the in-
dicators of function buttons (A), (B)
and (C) flash.
4. Press function button (B).
• The indicators of function buttons
(A) and (C) go off.
• The indicator of function button (B)
continues to flash.
• The end indicator is off.
5. Press function button (B) to change
the setting.
• The end indicator comes on. The
rinse aid dispenser is active.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse
aid.
8. Fill the rinse aid dispenser.
ENGLISH
596 / 818 - 898 / 550
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
31
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
