Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
For the installer
Fitting the non-powered extractor
hood
The non-powered extractor hood is fitted
to the wall or to the top kitchen cupboard.
The capture capacity improves, the lower
the extractor hood is placed. The recom-
mended fitting height is approx. 60cm
above a gas cooker and at least 50cm
above an electric cooker. This differs from
the fitting instructions for powered ex-
tractor hoods, where the temperature can
become excessively high and the motor
may be damaged if the extractor hood is
fitted too close to the cooker.
Mounting the non-powered extractor
hood
1 Remove the lower plate.
2 Place the niche pipe over the hole and
fasten the pipe by moving it a quarter
turn.
Wall mounting
2x screws, 2x mounting rings and 2
pairs of plugs are supplied for mounting
purposes. 1 pair of plugs is suitable for
concrete walls and for solid, non-concrete
walls. Suitable mounting materials must
be used for other types of walls and hol-
low walls. Make sure the wall to which the
extractor hood is to be mounted is flat.
1 Draw the mounting holes on the wall
and drill 2x ø8mm.
2 Mount the hood on the wall.
3 Make sure the hood is level and then
tighten the screws.
10 - EN
All manuals and user guides at all-guides.com
Top cupboard assembly
1 Remove the 4 caps on the top of the
hood.
2 Mount the hood to the top cupboard by
means of 4 screws(not included).
3 Click the cover into the cover arm (see
fig. 2).
4 Make the electrical connections for the
hood (see appendices).
5 Position the lower plate.
Note: The WK 600 has a 1.60m cable
without plug for the electrical connection.
Important, The outlet of the
extractor hood may not be con-
nected with the outlets of ap-
pliances heated by means other
than electrical energy.
settings graph and plate WK 600-1
Advertenties
Inhoudsopgave
