Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
connected or from the time of humidity drop set on the humidity sensor potentiometer�
ATTENTION: When the green diode located in the electronic system is on, it means that the humidity
level in the room is higher than the preset on the potentiometer controlling the humidity level
adjustment. As long as the diode is on, the fan will not start counting down the stop delay after
which the fan is switched off. It will take place only after the humidity level in the room drops and
the green diode goes off.
6 INSTALLATION
The bathroom extractor fan should only be installed, connected to electrical mains
and commissioned for use by qualified personnel in accordance with applicable laws!
Necessary
tools:
Installation procedure
• Determine the installation location of the fan�
• Prepare the power cable� Use NYM-O 2x1,5 mm² or NYM-O 3x1,5 mm² depending on the equipment
variant� If NYM-J 3x1,5 mm² or NYM-J 4x1,5 mm² cable is used in the installation, insulate the earth cable�
NOTE: Ensure that the power cable is not live before proceeding.
• Remove the push-fit hole plugs (9) using a pointed tool�
• Measure and drill the holes for the fan, the ø6 mm fixing pins (included in the package),
and then route the power cable shown in Figure 5�
• Remove the electrical cover (2) secured with screws (3)�
• Pass the double-insulated electrical cable through the passage (4)� The cable should be led in a length
that allows connection to the power terminals�
Before fixing the fan: Remove foreign objects from inside the fan; check that the rotor rotates freely
by setting it in motion with your hand; ensure there is enough space for the opening of the check
valve shutter located at the fan outlet;
It is recommended to connect the exhaust fan to the duct installation using flexible tubes!
• Place the fan body (5) and the mounting pins into the prepared holes�
• Secure the fan to the partition by screwing the screws into the fixing plugs, using the mounting holes (6)�
• Insert the mounting hole plugs
• Remove the outer insulation from the cable, remove the wire insulation to a length of 4 mm�
• Arrange the cable and connect it according to the connection diagram appropriate for the model
being installed�
• Ensure that the cable conductors are securely attached to the terminals�
• Check the fan for secure mounting and proper electrical installation�
• Adjust the parameters:
Applies to the DH version: Set the time delay value and humidity sensor sensitivity using the key (7) on
the potentiometers located on the controller (8)�
Fan 1500, Fan 1500 DH
Cross-tip screwdriver
Drill-driver
13
Advertenties
Inhoudsopgave
