Inhoudsopgave
Advertenties
3. Remove the fuse
.
9
4. Insert a new glass tube fuse (F5AL250V) onto the spring
5. Place the plug tip back on top of the new fuse.
6. Turn the screw cap clockwise to the 12V connector
7. Storage
- Allow the heated seat pad to cool completely.
- Store the heated seat pad in a clean, dry place.
- Keep the heated seat pad out of reach for children.
- Avoid that the heated seat pad is kinked during storage
by heavy objects being placed on it.
- Do not weigh down the heated seat pad with heavy
objects.
8. Troubleshooting
For faults not listed here, please contact the manufacturer.
Fault
Possible cause Rectification
The 12V
The heated
seat pad is
connector is not
not functio-
plugged into
ning.
the 12V vehicle
power connector.
There is no
voltage at the
12V vehicle
power socket.
The
The 12V electrical
ignition is
power socket
switched
fitting is dirty.
on but the
The contact
heated
is therefore
seat pad
interrupted
does not
The fuse of the
work.
12V plug has
blown.
The vehicle fuse
has blown
9. Technical data
Weight:
Measurement seat part: ca. 43,5 x 49 x 1 cm
Measurement rear part: ca. 54,5 x 49 x 1 cm
Measurement total:
External material:
Internal material:
Temperature max.:
Plug the 12V plug into
the 12V vehicle power
socket correctly.
In many vehicles, the
ignition must be turned
on for the 12V vehicle
power socket to be
live.
Clean the 12V vehicle
power socket properly.
Replace the fuse of the
12V plug, see section
Maintenance.
Replace the vehicle
fuse for the 12V
vehicle power
connector. Please refer
to the handbook for
your vehicle.
ca. 510g
ca. 98 x 49x x 1 cm
Polyester und Polypropylen
Polyurethane foam and Polyester
50° C
Power rating:
.
8
Power supply:
Protection class:
Fuse:
This heated seat pad has been tested by TÜV-TÜV Rheinland
Group (TÜV Kraftfahrt GmbH. Institute for Traffic Safety,
Type testing vehicles/vehicle parts, Am Grauen Stein,
51105 Cologne).
Suitability for side airbags rated and tested in comparison
with series production. See application range (type list) and
technical report no. 83SG0170. Retrieve under www.
walsergroup.com/clix
10. Declaration of Conformity
The EU declaration of conformity can be
requested from the manufacturer.
11. Disposal
11.1 Disposal of packaging
Dispose of the packaging separated by type.
Put paper board and cardboard in paper
recycling, and plastic films in material recycling.
11.2 Disposal of old appliances
(Applicable in the European Union and other European
countries with systems for separate collection of recyclables)
Old appliances must not be put in
household waste!
If the heated seat pad is longer usable, each
consumer is required by law to dispose
of old appliances separately from household
waste, e.g. at a collection site in his community/city
district. This ensures that old appliances are properly used
and negative effects on the environment are avoided.
Therefore, electrical and electronic equipment is marked
with the above symbol.
12. Manufacturer
Walser GmbH
Radetzkystraße 114
6845 Hohenems
Österreich
office@walsergroup.com
User manual status 26.3.2019
36,0 W (Low: 31,2 W,
High: 36 W)
12V
III
(6 x 30) mm, Typ F5AL250V
Advertenties
Inhoudsopgave
