Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Now connect the new illuminant to the energy
supply wire.
6. Push the wires back into the hole and fix the new
illuminant.
5. Trouble shooting
POSSIBLE CAUSE
The plug of the appliance is not
connected to the socket.
The plug has become loose.
The socket is not supplied with
energy.
The fuse is switched off.
Light is on but motor does not work.
ventilation damper blocked.
motor mounting defective.
motor defective
one-way valve is leaky
connection base chimney-telescopic
chimney is leaky
motor not properly fixed
hood not properly fixed
too much distance hood-hob
too much draught because of open
doors and/or windows
mounting rail is not firmly fixed
screws are not firmly tightened
If the hood does not work properly and/or you can hear increased operating noise,
All manuals and user guides at all-guides.com
MALFUNCTION
The appliance does not work at all.
Check the corresponding socket by
Check the fuse.
The voltage is too low. Compare the
remove blockage.
replace motor.
Abnormal motor-smells.
replace motor
Smear of oil.
seal the valve
seal the connection with a suitable
Appliance vibrates.
fix motor properly
fix hood properly
Insufficient extracting capacity.
lower position of hood
close the doors/windows
Appliance is unstable.
fix mounting rail properly
tighten the screws
check the schedule below:
32
MEASURE
connecting it with another appliance.
data on the model plate with the data
of your energy supplier.
material
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
