Advertenties
Beschikbare talen
Beschikbare talen
125987721_EN.qxp
2007-07-02
Adjusting the level of conductivity
Water contains, a variable quantity of limestone
and mineral salts of which quantities vary
according to geographical locations thus varying
its conductivity values.
Relevant variations of the conductivity of the
water compared to those prefixed by the factory
could slightly influence the residual humidity of
the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
To access adjustment mode:
Turn the programme selector dial to switch on the
appliance. In selection mode, press
simultaneously the buttons 2 and 4. Press the
buttons down until the pilot lights above each one
begin to flash and one of the pilot lights indicating
the drying phase lights
2
1
Adjusting the level of conductivity:
Press the button Start/Pause
level of conductivity is indicated by the lighting of
the horizontal hyphens.
22
09:38
Page 22
,
,
remains lit
4
3
sequentially: the
3
2
1
Display
Conductivity
degree
Low
Medium
High
Normally, the appliance is factory-set to the
highest level; however, certain models may
be configured differently.
Memorizing the new setting:
Simultaneously press the buttons 2 and 4. Press
the buttons down until the pilot lights above each
ones stop flashing and the buzzer sounds.
4
Approximative
value (μS/cm)
< 300
300 - 600
> 600
Advertenties
