Advertenties
Beschikbare talen
Beschikbare talen
Lamp Fitting
Base must be GY 9.5 and light center height shall
be 46.5 mm.
Damaged or thermally deformed lamps MUST NOT
be used. Lamp manufacturers' instructions must
be followed at all times.
Never attempt to insert a lamp with the spotlight
connected to a dimmer circuit or to the mains.
Before opening the spotlight, unplug the power
cable. Failure to observe this precaution may result
in severe burns. Do not touch the lamp surface -
use the disposable glove or shield provided with
the new lamp when fitting it into the lampholder.
When changing a recently failed lamp, allow time
for the lamp and lens to cool before removing it
from the spotlight.
Reflector Cleaning
Disconnect the power supply cable, open the lamp
tray beneath the spotlight and remove the lamp.
Clean the reflector using a slightly damp cloth with
some alcool.
Inserting Color Frame or Barndoor
All manuals and user guides at all-guides.com
EUROSPOT
Beam Spread Adjustment
Beam spread control for Fresnel and Prism Convex
spotlights is achieved by moving the lamp and
reflector in relation to the lens. Moving them
forward increases the beam angle and moving
them backwards reduces it. Control is by a screw
knob beneath the spotlight.
For profile spotlights with condenser optics,
a fine adjustment knob allows to trim the
sharpness difference between a light beam
shaped by shutters and a beam created from an
iris diaphragm or a gobo. For profile spotlights
with ellipsoidal reflector the fine adjustment knob
allows to adjust the homogenity of the light beam.
On all profile spotlights, the zoom system allows to
control the beam diameter. The zoom lenses are
moved by first loosening the 2 adjustment knobs
beneath the spotlight and then sliding them to
the required positions. Once the desired setting is
achieved, tighten the knobs to secure the lenses.
Lens Cleaning
Clean the lenses using a slightly damp cloth with
some alcool. With Fresnel and prism convex
spotlights, remove the 4 screws from front of spot,
remove the front plate, clean the lens and replace
the front plate. With profile spotlights, remove top
centre screw from front of spot, pull top baffle plate
forward as far as possible and clean the lenses.
Slide top baffle plate back to its initial position and
replace retaining screw.
P a g e
7
Issue 001
Advertenties
