Advertenties
Beschikbare talen
Beschikbare talen
EUROSPOT
Generalities
This information is given in the best interest of safety,
handling, installation, use and maintenance of the
product. They must be read before any attempt is
made to use and/or install the product. Additional
copies are available on request.
•
The luminaires must not be covered by heat
insulating material or by any other material
which prevents proper heat dissipation.
•
Observe carefully the limitation on the
minimum distance between inflammable
materials and any part of the luminaire as
indicated on the identification plate.
•
Luminaire enclosures should not be opened
immediately after switching off and adequate
time must be allowed for lamp to cool.
•
Do not operate luminaires without safety glass
and /or lenses.
•
Replace all cracked or damaged safety glasses
and/or lenses immediately.
•
For safety reasons, failed lamps should be
replaced promptly and the luminaire should
be switched off as soon as the lamp failure is
noted.
•
Unless otherwise stated, the luminaires are
designed for direct connection to a standard
mains supply as indicated on the identification
plate.
•
Inspection and cleaning should be carried out
at regular intervals to ensure electrical and
thermal safety as well as optical performance
of the luminaire.
•
Servicing, cleaning or lamp replacement should
only be carried out after the power supply cable
has been disconnected.
•
Repairs should be carried out only by sui-
tably qualified personnel. Only spare parts
authorised by ADB may be used.
•
ADB products must not be modified. Any
modification may render the product unsafe,
and will invalidate any safety approval marks.
ADB will not accept any liability for any damage
caused as a result of such a modification.
P a g e
6
Issue 001
All manuals and user guides at all-guides.com
Fitting Plug
A suitable plug of at least 10/16A (220 V / 240V)
rating should be fitted to the spotlight power cable,
observing the connection colour code as follows :
Important Remark
Power supply cables and other connections are
essential for your equipment and contribute greatly
to a safe and trouble free operation.
•
•
•
Remark: the weight of the accessories shall not
be more than 25% of the weight of the luminair.
Inserting Shutter Blades
•
•
•
•
Brown or black - phase
Blue - neutral
Yellow, green -
Earth/Ground
Always hold the plug when disconnecting a
cable, never pull the cable.
Never use cables or connections in bad
condition, check them before installation and
periodically thereafter.
Never tie power supply and data cables
together.
Place the lateral shutter blades near the lamp
and the vertical shutter blades near the lens.
Insert corner (A) between notches in shutter
blade slot (C).
Push blade in until notch (B) engages in extreme
edge of slot. This will allow clearance for corner
(D) to be rotated fully into the housing.
Repeat in rotation until all shutter blades are
securely home.
Advertenties
