Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
38
TROUBLESHOOTING
The appliance does not start or it stops
during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
Service.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
The programme
does not start.
The appliance does
not fill with water.
The appliance does
not drain the water.
After the checks are completed, acti-
vate the appliance. The programme
continues from the point of interrup-
tion.
Possible cause
The mains plug is not con-
nected in the mains socket.
The appliance door is open. Close the appliance door.
You did not press Start.
The fuse in the fuse box is
damaged.
The delay start is set.
The water tap is closed.
The water pressure is too
low.
The water tap is clogged or
there is limescale on it.
The filter in the water inlet
hose is clogged.
The water inlet hose has a
kink or a bend.
The anti-flood device is on.
There are water leakages in
the appliance.
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you make the checks.
Possible solution
Connect the mains plug.
Press Start.
Replace the fuse.
Cancel the delay start or
wait for the end of the
countdown.
Open the water tap.
Contact your local water au-
thority.
Clean the water tap.
Clean the filter.
Make sure that the position
of the hose is correct.
Close the water tap and
contact Service.
Clean the sink spigot.
Make sure that the position
of the hose is correct.
If the problem occurs again, contact
Service.
If the display shows other alarm codes,
contact Service.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
