Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Operation
a. Operation
General
The VDPC174 allows you to program 12 scanners with 16 DMX channels each, 30 banks of 8 programmable
scenes, 6 chases of 240 scenes and all this by means of 8 channel sliders, a joystick and other buttons. By
means of the joystick you can easily and more accurately control the movement of a fixture. To increase
your ability to dazzle the audience, this unit allows you to assign and reverse DMX channels. In addition, two
units can set up communication so that they can send or receive a complete file dump.
Display Information
The LCD display contains a maximum of 2 lines, each of 8 characters. Below are the definitions:
LCD Display
b. Setup
Unit Setup
The unit is preset to allocate 16 channels per fixture. In order to assign your fixtures to the
scanner buttons located on the left side of the unit you will need to space your fixtures 16 DMX
channels apart.
Use the following chart for DMX addressing:
Fixture
Number
1
2
3
4
5
6
7
8
9
10
11
12
Enabling the PROGRAM Mode
To enable the PROGRAM mode, hold the PROGRAM button for a few seconds until the LED is lit.
Setting Up the Joystick
1. Press and hold the PROGRAM button until the LED is lit.
2. Press and hold the MODE and FINE buttons simultaneously. The assign LED should light. If the
V. 02 – 14/06/2018
Scene 1
Bank 1
Chase 1 is activated
The ninth step of a chase
DMX value (000 ~ 255)
The current speed is 1 minute and 54 seconds
The time of the last two taps is 4.25 seconds
Assign DMX channels 4 and 5
Reverse DMX channels 10 and 13
Digital DMX Address
1
17
33
19
65
81
97
113
129
145
161
177
VDPC174
Description
Scanner DIP Switch Setting
1 is ON
1 and 5 are ON
1 and 6 are ON
1, 5 and 6 are ON
1 and 7 are ON
1, 5 and 7 are ON
1, 6 and 7 are ON
1, 5, 6 and 7 are ON
1 and 8 are ON
1, 5 and 8 are ON
1, 6 and 8 are ON
1, 5, 6 and 8 are ON
5
©Velleman nv
Advertenties
Inhoudsopgave
