Download
Deel
Print deze pagina
  1. Handleidingen
  2. Merken
  3. Kärcher Handleidingen
  4. Hogedrukreinigers
  5. HDS-E 8/16-4M 12kW
  6. Originele gebruiksaanwijzing

Kärcher HDS-E 8/16-4M 12kW Originele Gebruiksaanwijzing pagina 21

Verberg thumbnails Zie ook voor HDS-E 8/16-4M 12kW:

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 56
Adjusting the dosage of the system
care Advance RM 110/RM 111
 Determining the hardness of tap water:
through the public water supply works,
–
using a hardness tester (order no.
–
6.768-004)
Water hard-
Scale on the system care
ness (°dH)
service switch
<3
OFF (no dosing)
3...7
1
7...14
2
14...21
3
>21
4
 Set the service switch according to the
water hardness in the table.
Note: Observe the following when using
system care Advance 2 RM 111:
Calcification protection: See table
–
Pump care: Set the service switch to at
–
least setting 3.
Refill detergent
Caution
Risk of injury!
Use Kärcher products only.
–
Under no circumstances fill solvents
–
(petrol, aceton, diluting agent etc.)
Avoid eye and skin contact.
–
Observe safety and handling instruc-
–
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
 Refill detergent.
Install the hand-spray gun, the jet
pipe, the nozzle and the high
Figure 4
 Connect ray tube with hand spray gun
 Tighten the screw connection of the
spray lance fingertight.
 Insert high pressure nozzle into cover-
ing nut
 Install covering nut and tighten firmly
 Connect the high pressure hose to the
high pressure connection point of the
machine.
Installing spare high pressure hose
Figure 5
Water connection
For connection values refer to technical
specifications
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note: The supply hose is not included.
Power connection
For connection values, see technical
–
data and type plate.
The electrical connections must be
–
done by an electrician according to IEC
60364-1.
The voltage indicated on the type plate
–
must correspond to the voltage of the
electrical source.
The installation of the electrical plug
–
may only be performed by the author-
ised customer service/electrician. The
electrical plug is not included.
Danger
Danger of injury by electric shock.
Unsuitable extension cables can be
–
hazardous. Only use extension cables
outdoors which have been approved for
this purpose and labelled with a suffi-
cient cable cross section:
– 4
EN
pressure hose
21

Advertenties

loading

Gerelateerde Handleidingen voor Kärcher HDS-E 8/16-4M 12kW

Gerelateerde Producten voor Kärcher HDS-E 8/16-4M 12kW

Deze handleiding is ook geschikt voor:

Hds-e 8/16-4m 24kwHds-e 8/16-4m 36kw