Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8. Adjusting the metal detector to your body height
The product is delivered fully assembled.
Follow the steps below to adjust the length of the pole:
• Test the length setting. If necessary, readjust the length until you find a comfortable position.
Avoid fully unscrewing the thread, otherwise the threaded ring may fall off and get lost. Do not twist or pull
on the interior cable.
• Loosen the knurled nuts on the swivel joint (2).
• Adjust the horizontal position of the detection probe (1) so that it will always be parallel to the ground, and then
tighten the knurled nuts slightly with your hand. You should still be able to adjust the detection probe (1) with your
hand, but it should not slide out of position.
• Tighten the knurled nuts on the swivel joint (2) so that the position of the detection probe (1) will not change when
you are searching for metal objects.
All manuals and user guides at all-guides.com
• Change the length of the pole to adjust the metal detector to suit your height.
• Adjust the length so that you can move the detection probe (1) over the
ground at a height of approximately 3-5 cm without having to bend over. When
searching for metal objects, ensure that you stand straight with a balanced
body posture (see left-hand diagram).
• Loosen the connection sleeve (4) by turning it clockwise.
• Pull the lower telescopic pole (3) outwards to the desired position. The bottom
of the metal detector should be parallel to the ground when you are searching
for metal objects.
• Turn the connection sleeve (4) anticlockwise to secure the pole in place at the
desired length.
23
Advertenties
Hoofdstukken
Inhoudsopgave
