ENGLISH
2. Keep the knob pushed for about 5 sec;
this will allow thermocouple to heat up,
and the safety device to switch off, other-
wise the gas supply would be interrupted.
3. After the flame is regular, adjust it as pre-
ferred.
If after a few attempts the burner does
not ignite, check that the crown and its
cap are in correct positions.
1
Burner cap
2
Burner crown
3
Ignition candle
4
Injector
5
Thermocouple
Warning! Do not keep control knob
pressed for more than 15 seconds.
If the burner does not light after 15 seconds,
release the control knob, turn it into off posi-
tion and wait for at least 1 minute before try-
ing to light the burner again.
Helpful hints and tips
Energy savings
• If possible, always place lids on the pans.
• As soon as liquid starts boiling, turn down
the flame to barley keep the liquid simmer-
ing.
Use pots and pans with bottom fitting the size
of burner used.
All manuals and user guides at all-guides.com
1
2
3
4
5
Important! In the absence of electricity You
can ignite the burner without electrical
device; in this case approach the burner with
a flame, push the relevant knob down and
turn it counter-clockwise to maximum gas
release position.
Warning! Maintain extreme caution
while operating with open fire in kitchen
environment. Manufacturer declines any
responsibility in case of misuse of flame.
If the burner accidentally goes out, turn
the control knob to the off position and
wait for at least 1 minute before trying to
light it again.
When switching on the mains, after in-
stallation or a power cut, it is quite nor-
mal for the spark generator to be activated
automatically.
Turning the burners off
To put the flame out, turn the relevant control
knob to the symbol
Warning! Always turn the flame down
or switch it off before removing the pans
of the burner.
Burner
minimum di-
ameter of pots
and pans
Rapid
180 mm
Auxili-
80 mm
ary
The bottom of the cookware should be as
thick and flat as possible.
.
maximum di-
ameter of pots
and pans
260 mm
160 mm
6