Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
manual - OBlOnG
Stainless steel steps
The stainless steel interior steps are
assembled according to the instructions
and are attached on top of the border .
not suitable in salted water !
1) Define the place of the steps holders
80 mm from the inside of the coping .
2) Bore out two holes for the holders
with a brace diameter 50 mm .
1
ø50 mm
2
3
58
3) Place the two holders and screw
them with the screws which were also
supplied .
4) Place the rubber pieces at each end
of the stainless steel steps, for the
protection of the liner .
80 mm
4
ground
5) Place the metal covering plates over
the holders and install the steps .
6) Place the supporting plank and screw
it (see assembly 2 .2 .2 .) .
5
6
Advertenties
Hoofdstukken
Inhoudsopgave
