Advertenties
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your multitool has been designed for light
sanding, sawing and scraping applications.
1. On/off switch
2. Speed adjustment wheel
3. Mounting point for accessories
4. Grip
5. Allen key
6. Allen key holder
13. Carbon brush cover
ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the sanding pad and
the sanding paper (fig. B)
The sanding pad and the sanding paper must be
used for sanding applications.
Mounting
• Place the machine on a table with the mounting
point (3) facing upwards.
• Loosen the Allen screw (7) using the Allen key (5).
• Mount the sanding pad (9) to the mounting point
(3).
• Tighten the Allen screw (7) using the Allen key (5).
• Mount sanding paper (10) with the required
grain size onto the sanding pad (9). Make sure
that the perforation in the sanding paper (10)
corresponds with the perforation on the sanding
pad (9).
- Use coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
- Use medium sanding paper (grain 80) for
removing the remaining scratches from the
6
coarse sanding paper.
- Use fine sanding paper (grain 120) for
finishing surfaces.
Removing
• Place the machine on a table with the mounting
point (3) facing upwards.
• Remove the sanding paper (10) from the sanding
pad (9).
• Loosen the Allen screw (7) using the Allen key (5).
• Remove the sanding pad (9) from the mounting
point (3).
• Tighten the Allen screw (7) using the Allen key (5).
Mounting the dust extraction (fig C1 + C2)
The dust extraction piece can be used to connect
the machine to a vacuum cleaner when sanding.
Dust will be extracted and your work area stays
cleaner.
the dust extraction adapter can only be
used in combination with the sanding
pad (9).
To install the dust extraction adapter:
• If not done yet, remove the accessories from
the machine spindle (3).
• Assemble the dust extraction parts (15A to
15D) together like shown in (Fig. C1 and C2)
• Click the adapter to the machine spindle until
it fixes well, make sure the rear fingers (15C)
click into the gaps on the machine housing.
• Add the felt ring (15E) between the pad and the
adapter for a tight sealing and assemble the
sanding pad like instructed in previous chapter.
• Connect a vacuum cleaner to the adapter end
(15D).
Mounting and removing the saw blade (fig. B)
The saw blade must be used for sawing applications.
Mounting
• Place the machine on a table with the mounting
point (3) facing upwards.
• Loosen the Allen screw (7) using the Allen key (5).
• Remove the spacer (8).
• Mount the saw blade (11) to the mounting point
(3).
• Mount the spacer (8).
• Tighten the Allen screw (7) using the Allen key (5).
Advertenties
