Download Inhoudsopgave Inhoud Print deze pagina

Position Of Limit Switches; Product Maintenance; Disposal Of The Product; Inspecting The Automation - Nice M-Fab ME3000 Aanwijzingen Voor Installatie En Aansluiten

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 26
6
Black = Encoder
Grey = Encoder
Yellow/Green =
WARNING! – The motors are equipped with a 2-meter cable.
Making junctions inside the box IS FORBIDDEN. For any connections
use only the appropriate connector block (not included) in order to
ensure the safety of the system.

4.2 - Position of Limit Switches

See fig. 6.
5

INSPECTING THE AUTOMATION

Testing of the entire system must be conducted by experienced and qualified
personnel, who must establish what tests are necessary depending on the
risks involved. To test M-FAB proceed as follows:
• close the gate;
• disconnect the power supply to the control unit;
• release the gearmotor from the gate leaf as shown in paragraph "Manual
release device (Key and Lever-Operated Release)" in Chapter "Instructions
and Warnings for Users of the M-FAB Gearmotor".
• open the gate manually all the way;
• make sure the gate opens and closes smoothly without any points of friction;
• make sure that the gate, when stopped in any position and released, does
not display a tendency to start moving again;
• make sure that the safety systems and mechanical stops are in good working
order;
• make sure that the screw connections are properly tightened;
• clean the inside of the box and make sure that the drain operates properly;
• when all the checks have been completed, re-connect the gearmotor and
power the control unit;
• M-FAB is not equipped with any torque adjustment device, therefore this
operation is performed by the control unit;
• measure the impact force as provided by the EN12453 and EN12445 stand-
ards.
3 – English
6

PRODUCT MAINTENANCE

M-FAB does not require any special maintenance; however, routine checks
conducted every six months at least will ensure the long life of the gearmotor
as well as the correct and safe operation of the system.
Maintenance consists simply in repeating the testing procedure.

DISPOSAL OF THE PRODUCT

This product is an integral part of the automation, and therefore, they
must be disposed of together.
As for the installation operations, at the end of the life of this product, the dis-
mantling operations must be performed by qualified personnel.
This product is made from different types of materials: some can be recycled,
others must be disposed of. Please inform yourselves on the recycling or dis-
posal systems provided for by the laws in force in your area, for this category
of product.
CAUTION! – some parts of the product can contain polluting or dangerous
substances which, if dispersed in the environment, may cause serious harm to
the environment and human health.
As indicated by the symbol at the side, it is forbidden to throw
this product into domestic refuse. Therefore, follow the "separat-
ed collection" instructions for disposal, according to the meth-
ods provided for by local regulations in force, or redeliver the
product to the retailer at the moment of purchase of a new,
equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy sanc-
tions in case of abusive disposal of this product.

Advertenties

Inhoudsopgave
loading

Inhoudsopgave