Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fault
HomeConnect is not work-
ing correctly.
The base of the refrigerator
compartment is wet.
Information on display panel
Fault
Message showing "D" or "E"
appears in the display.
The temperature display
(freezer compartment)
flashes.
The temperature display
(freezer compartment)
flashes, a warning signal
sounds and
lights up.
Cause
Different causes are pos-
sible.
The condensation channel
or drainage hole are
blocked.
Cause
The electronics have detec-
ted a fault.
The temperature in the
freezer compartment was
too warm.
Different causes are pos-
sible.
The appliance door is open.
The ventilation openings are
covered up.
Larger quantities of fresh
food have been put in.
Troubleshooting en
troubleshooting
Go to www.home-connect.com.
▶
Clean the condensation channel
▶
and the drainage hole. → Page 31
troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 37
Press
.
1.
a The temperature display (freezer
compartment) briefly indicates the
warmest temperature reached in
the freezer compartment. The tem-
perature display (freezer compart-
ment) then indicates the set tem-
perature again.
Press
.
2.
a The temperature display (freezer
compartment) no longer flashes.
Press
.
▶
a The alarm is switched off.
Close the appliance door.
▶
Remove any obstructions from in
▶
front of the ventilation openings.
Do not exceed the max. freezing ca-
▶
pacity.
→ "Freezing capacity", Page 27
33
Advertenties
Hoofdstukken
Inhoudsopgave
