I
NOTE
Ensure that the power supply cable is not
accessible through cabinet doors or
drawers after installation.
1. Ensure that the distances are maintained as
specified in fig. 3, page 3.
2. Cut out the working surface, see fig. 4,
page 4.
The thickness of the working surface must be
10 – 40 mm.
3. Mount the brackets on the working surface,
see fig. 5, page 4.
4. Mount the spacer to the cooktop, see fig. 6,
page 4.
5. Mount the cooktop to the brackets, see
fig. 7, page 5.
6. Connect the power cable, see fig. 8,
page 5.
Operation
!
WARNING! Damage hazard
• Do not slide cookware over the cook-
top.
• Lift the cookware when you want to
remove it from the plate.
!
CAUTION!
Verify that the voltage and frequency of
the mains supply of the ship matches the
marking of the device.
Observe the following hints and recommenda-
tions:
• If the device is intended to operate by inverter
power, the inverter should have a minimum con-
tinuous out put rating of at least 2300 W and be
connected to a lithium battery bank with a bat-
tery management system that is capable of
applying the necessary loads.
• If you are using an inverter with a power output
of less than 2000 W, only one induction zone
should be used at a time.
EN
• CVI1525 only: Both induction zones can be
used with rnains power supply. However, the
shore power input of a recreational vehicles is
limited to 15 A. The operation of multiple
AC devices, e.g., air-conditioner, hot water
systems, or air fryers, at the same time may over-
load the recreational vehicle's input. In this case
reduce the load and reset the fault-current circuit
breaker, if necessary.
• The buttons respond to touch. Do not use pres-
sure to operate the buttons.
• Use the fingertip and not the fingernail to oper-
ate.
• Ensure the buttons are always clean and dry so
that the operation is not affected.
Choosing the right cookware
!
WARNING! Health hazard
Do not heat up empty pots or pans and
do not use cookware with a thin bottom.
The cookware can heat up very quickly.
The bottom of the cookware can melt
and damage the glass plate.
A
NOTICE! Damage hazard
Do not use cookware with jagged edges
or a curved base.
I
NOTE
• Only use cookware with a base suit-
able for induction cooking.
• Do not use cookware made of pure
stainless steel, aluminum or copper
without a magnetic base, glass, wood,
porcelain, ceramic and earthenware.
➤Perform a magnet test to check if your cookware
is suitable for the operation of the cooktop by
moving a magnet towards the base of the cook-
ware.
✔ The cookware is suitable for the cooktop when
the magnet is attracted to the cookware.
➤Use cookware with a bottom diameter of
min. 140 mm.
4445103517
11