Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
locked when the locking device
independently returns to its original
posi tion
.
Disassembly of joint brush followed
by assembly of the surface brush
Dismantle the joint brush according to
handling and function described above.
Open the locking device (K)
17
drive arm (P) and, with the lock
applied, (K) put the drive arm (P) with
safety guard (O), onto the drive side of
the motor/gear unit (L), as illustrated.
Release the spring-loaded lock (K),
the drive arm is locked when the
locking device independently returns
to its original position
NOTE!
If the drive unit (P) cannot be pushed
17
onto the drive shaft, reach under the
safety guard (O) and turn the hexago-
nal drive until the drive unit (P) slides
onto the drive shaft easily and without
force.
Put the surface brush (N) onto the
18
hexagonal drive and then the guide
arm (M), as illustrated, on the steering
side of the motor/gear unit (L).
Now slide the lock (K) into open posi-
19
tion
, hold this and press the guide
arm (M) further onto the coupling
shaft up to the stop. Release the
spring-loaded locking device (K).
The guide arm (M) is locked when the
locking device independently returns
to its original position
of the
.
.
27
NOTE!
Whilst assembling the surface brush,
20
make sure that the side part of the
safety guard on guide arm (M) is
firmly connected to the safety guard
and is correctly sealed.
6.1.3 Using the surface brush on
rough surface structures e.g. tiles,
paving slabs, exposed aggregate
concrete, stoneware etc.
Figure 21
Place the switched-on device parallel
21
on the surface to be treated. Hold the
device at working angle and make
sure that the rubber lip on the safety
guard is just above the ground.
Walk at an even steady pace and push
the device in front of you.
Depending on the degree of soiling,
apply light to medium pressure on the
surface brush, adapt your pace of
work to the degree of soiling.
NOTE!
Always work parallel and hold the
device away from your body.
When working close to edges, the
narrower side of the device should
point towards the wall.
In cases of stubborn dirt you can move
the device backwards and forwards on
the spot (like a scrubber), until the
required result is achieved.
Moist cleaning is also possible in cases
of heavy soiling.
Use a sprayer to moist the surface to
be cleaned with water or a cleaning
agent, a GLORIA sprayer is ideal for this
purpose.
After moit cleaning rinse the surface
with water.
Advertenties
Hoofdstukken
Inhoudsopgave
