Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
42
Fitting the hob to the worktop
Carry out the building in of the hob as
follows:
1. Place the seals supplied with the hob on
the front edge of the cut out. Then,
place them at 86 mm from the side
edges and at 10 mm from the rear edge,
as shown in figure 6, taking care that
the seals meet without overlapping.
2. Place the hob in the cut out, taking care
that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the injectors kit
(see fig. 7).
When the screws have been tightened,
the excess seal can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.
All manuals and user guides at all-guides.com
a) seal
Fig. 6
a
Fig.7
Advertenties
Hoofdstukken
Inhoudsopgave
