Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
30
Operation
Hob burner control knobs
The symbols on the knobs mean:
•
= no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before
putting a pan on the pan support.
To light the burners
To light a burner, turn the relevant
knob anticlockwise to maximum position
(
) and push down the knob to ignite.
After lighting the flame, keep the knob
pushed down for about 5 seconds. This will
allow the "thermocouple" to be heated and
the safety device to be switched off,
otherwise the gas supply would be
interrupted.
Then, check the flame is regular and
adjust it as required.
If you cannot light the flame even after
several attempts, check the "cap" (see fig.
letter A) and "crown" (see fig. letter B) are
in the correct position.
In the absence of electricity, ignition
can occur without the electrical device; in
this case approach the burner with a flame,
push the relevant knob down and turn it
anti-clockwise until it reaches the "maxi-
mum" position.
To switch off burners
To put the flame out, turn the knob to
the "off" position (
).
•
All manuals and user guides at all-guides.com
Triple crown burner
A
B
D
C
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
Advertenties
Hoofdstukken
Inhoudsopgave
