Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.
The row of LED indicators (6) displays the voltage supplied by the battery. Every LED
shows a value from 18 to 24V.
7.
The LED for the status of charge (7) can light up in 2 colours:
a. Green if the battery is fully charged
b. Red if the battery is empty or the unit is overheated.
In the latter case, the unit switches immediately off and should only be switched on
again if the defect is removed.
8.
The LED for the power supply (8) can also light up in 2 colours:
a. Green indicates that the unit is switched on and powered by the built-in battery.
b. Orange indicates that the 220Vac lead is connected and the battery is charged.
9.
The 4-band tone control and the balance control (9) are used to set the sound
reproduction and the split over the speakers. These controls have no function when the
equalizer function is switched off.
10. The DVD control (10) sets the volume of the DVD sound.
11. The ECHO control (11) sets the number of echoes of the microphone.
12. The DELAY control (12) sets the delay of the microphone sound.
13. The volume controls (13-15) set the volume of each individual microphone. Take into
account the following;
a. Set the volume to the minimum if the microphone is not used
b. Never set the volume to the maximum in order to ensure an optimal sound
reproduction
c. When setting the volume, always start at the minimum and increase gradually.
d. When you don't use the microphone any more, set the volume down to zero.
14. The volume button for the LINE signal (16) sets the volume of the audio source that is
connected to the LINE IN socket on the rear panel.
15. The jack sockets (17 – 19) are for connection of microphones.
16. The volume control (20) sets the general volume.
The functions of the DVD player and the cassette deck are in most cases self-explanatory. The
remote control for the DVD player with its extensive control options is explained further down
the manual.
The L/R button (21) in the DVD section switches the sound reproduction to left, right or both
(VCD option).
The N/P button (22) switches the picture format between NTSC and PAL. If you notice that the
picture is not sharp enough and doesn't fill the screen, you can switch via this button to the
correct setting.
Advertenties
Inhoudsopgave
