Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Unit installation
Install the compressor on a level surface in a well-ventilated room with adequate space.
Room temperature should not exceed 35°C.
1. Remove the protectors.
2. Screw on the regulator.
3. Connect the airbrush and the compressor with a hose.
1
Beginning of operation
Connect the compressor to the power supply system. Turn the on/off switch to I (on)
The compressor is fitted with an automatic shut-off switch. The shut-off switch automatically deacti-
vates the motor after it has built up the maximum pressure required.
The motor is automatically reactivated when the pressure reaches three bar in the event of air being
removed from the pressure tank.
Setting the working pressure
The desired working pressure can be set with the pressure regulator. The working pressure is indica-
ted on a pressure gauge
1.
Pull the knob upwards.
2.
Increasing the pressure: Turn the knob in a clockwise direction.
Reducing the pressure: Turn the knob in an anticlockwise direction.
3.
Push the knob downwards again after the desired working pressure has been set.
1
Ausgabe 07.1
2
2
3
3
ENGLISH 13
Advertenties
Inhoudsopgave
