Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Machine in use with direct water connection
Connect the water connecting hose to the water supply adapter (image 1).
When using the machine with direct water connection, please turn the valve to the side of the water supply
adapter (image 1). The water supply valve is located in the rear part of the bottom panel (image 1).
Additionally, place the switch behind the drip tray into position "1" (image 2). Please make sure that your
water tap is always open during water-connection usage so that the machine never runs out of water!
image 1
Machine in use with water tank
When using the machine with water tank, please turn the valve into the direction of the machine foot (image
3). Additionally, place the switch behind the drip tray into position "0" (image 4).
image 3
Important
• Please make sure that only experienced specialists are connecting the machine to the
water supply and installing a pressure regulator.
• To avoid calcification of the machine a water softener is recommended. An 8l-water
softener (item.-no. 89530) is available in the ECM range of products.
Important
• In case you should decide on a direct connection of the machine to the drain system, a hole
has to be drilled in the bottom of the drip tray. This alteration can be carried out by
experienced specialists or by ECM Manufacture service.
• Connect a hose (inner diameter 15 mm) to the designated connector on the back side of
the machine and to a preinstalled siphoned drain.
Translation of the original German user manual
Valve in position for operating
machine with direct water connection
Place switch into position "1" for
direct water connection
Water supply adapter
Valve in position for operating machine
with water tank
Place switch into position "0"
when operating machine with water tank
Machine foot
ENGLISH
image 2
image 4
22
Advertenties
Inhoudsopgave
