Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 4.
1. On/off switch
2. Lock-off button
3. Locking knob for slot depth
4. Scale for slot depth
5. Spindle lock button
6. Guard
7. Base
8. Guide roller
9. Dust extraction connection
10. Main grip
11. Auxiliary grip
12. Allen screws
13. Allen key
14. Spindle
15. Outer flange
16. Flange key
17. Cutting disc
18. Spacers
19. Cutting disc
20. Spindle sleeve
21. Inner flange
22. Dust extraction adapter
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Replacing the cutting discs (fig. B - D)
Worn or damaged cutting discs must be replaced
immediately.
8
All manuals and user guides at all-guides.com
- Only use sharp and undamaged cutting
discs.
- Only use cutting discs that are suitable
for the material to be worked.
- Only use cutting discs with a maximum
permitted speed that is equal to or
exceeds the maximum no-load speed
of the machine.
- Only use diamond cutting discs that are
suitable for dry cutting.
- Always replace both cutting discs at the
same time.
- Never attempt to remove the guard.
• Place the machine on a stable surface.
• Loosen the Allen screws (12) using the Allen
key (13).
• Loosen the locking knob (3) and lower the base
(7).
• Remove the guard (6).
• Keep the spindle lock button (5) pressed to lock
the spindle (14).
• Loosen the outer flange (15) using the flange
key (16).
• Remove the old cutting disc (17), the spacers
(18), the old cutting disc (19), the spindle
sleeve (20), and the inner flange (21).
• If necessary, clean the flanges (15 & 21).
• Mount the inner flange (21), the spindle sleeve
(20), the new cutting disc (19), the spacers
(18), and the new cutting disc (17).
• Firmly tighten the outer flange (15) using the
flange key (16).
• Release the spindle lock button (5).
• Mount the guard (6).
• Raise the base (7) and tighten the locking knob
(3).
• Firmly tighten the Allen screws (12) using the
Allen key (13).
4. OPERATION
Setting the slot width (fig. B - E)
The slot width can be set using the spacers be-
tween the cutting discs. The number of spacers
between the cutting discs determine the slot width.
- Do not set the slot width during use.
- Always mount at least one spacer
between the cutting discs.
WWW.VONROC.COM
Advertenties
Inhoudsopgave
