Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. Move the cover left at the top of the door to the
right at the top of the door. Then lift the door and
place it on a soft surface to prevent scratches.
5. Loosen the pin on the bottom hinge, turn the hinge bracket around and
screw the pin back in.
6. Mount the bracket on the lower hinge pin.
Screw on both levelling feet.
7. Place the door on the bottom hinge again.
Make sure that the door is aligned horizontally
and vertically so that the seals on all sides fit
tightly onto the door before permanently
mounting the top hinge.
8. Place the top left hinge on top of the
appliance and screw tight.
9. Use a spanner to tighten it, if necessary.
52
All manuals and user guides at all-guidesbox.com
10. Replace the hinge cover and the screw.
11. After tightening the hinges, check that the
door seals are in good alignment with the
refrigerator casing throughout. If this is not the
case, the rubber seal can easily be pulled off,
turned 180° and then pressed back into
the rebate.
12. Checking and cleaning the rubber seals
a. Method 1: Clamp a thin piece of paper in
various places. The paper should be difficult to pull out in all
these places.
b. Method 2: Place a torch on a shelf inside the appliance and aim the
light at the seal; close the door and see if you can see any light.
If the seal is uneven, heat the seal rubber in the affected areas with a
hairdryer and shape them with your fingers.
Keep the door seals clean. Sticky food and drink can make the seals stick to
the cabinet and then tear when you open the door. Clean the seal with a mild
detergent and warm water. After cleaning, rinse well and dry. Caution! Do
not switch on the appliance until the door seals are completely dry.
53
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
